|
Rothwell Attenuators |
||
|
|
The shimmering, transparent sound of pure silver.
We are proud to offer the World-famous Rothwell attenuators - the highest quality, lowest-loss way to reduce the overall gain of a hi-fi system - eradicating problems such as overload distortion in pre-amps caused by overly hot outputs from CD players and channel balance problems caused by the volume control having to be set too low. Available in RCA or XLR versions. A perfect partner for our pure silver interconnect cables. The improvements that can be made to the overall sound of a system with these devices are of fundamental significance. On a "sound-per-pound" basis, they must be some of the best value hi-fi accessories you can buy. Back to main Rothwell products page
The attenuators as described by Rothwell: "Here's the solution to a problem from which far too many audiophiles suffer - too much gain in the system. The symptoms are easy enough to spot - the volume is plenty loud enough with the volume control set to the 9 o'clock position, too loud with the volume control at 10 o'clock, and fine control at low levels is impossible. This may seem like nothing more than a minor irritation, but in truth the performance of the system is being compromised. Although potentiometers work reasonably well over most of their operating range, they are notoriously problematic at extreme settings. The most obvious problem is channel imbalance - one channel will fade out (or fade in) quicker than the other, causing the stereo image to shift to one side - but on a more subtle level, the music may sound veiled and indistinct with the volume control turned down to the point where it is nearly off. Some people have tried to cure the problem by fitting a more expensive volume control only to find that it doesn't do much good. That's because the volume control isn't really the problem.
It’s the excess gain in the system which is the real problem. That in turn
forces you always to use the volume control over a very limited portion of
its travel. What's needed is a way to reduce overall system gain without
compromising sound quality and without major modifications to the
equipment itself. Although the
attenuators can be used on the inputs of the pre-amp in exactly the same
way as they would be used on an integrated amp (with the same benefits),
alternatively they can be used between the pre-amp and the power amp to
even greater effect. When used this way, not only is system gain reduced
by 10dB, but the signal to noise ratio is improved by 10dB. This pushes
the noise floor down enough to create an inky black silent background from
which the music can emerge with better resolved fine detail and
transparency. This applies to even very high-end and very expensive
pre/power amps. Review by Hi-fi+ Magazine - click here.
Order a pair of RCA Rothwell Attenuators: £39 (free shipping to the UK and European Union. If you live outside of these areas, please contact us before ordering for a shipping quote) Please allow up to 14 days before dispatch for Rothwell products
Order a pair of XLR Rothwell Attenuators: £69 (free shipping to the UK and European Union. If you live outside of these areas, please contact us before ordering for a shipping quote) Please allow up to 14 days before dispatch for Rothwell products
Back to main Rothwell products page
|